The Mobile Client allows you to set partition parameters such as alarm
duration, auto arm, and auto disarm. A partition is an independent control system of a
security control panel. It allows you to batch arm/disarm all zones in it. If the security
control panel has two partitions, you have two independent systems for arming or
disarming.
-
On the device list, tap the security control panel and then log in to the
device (if required) to enter the Partition page.
-
Tap More to enter the Settings page.
-
Configure parameters for the partition.
- Auto Arm
-
Enable the partition to automatically arm itself in a specific
time point.
- Auto Arm Time
-
Set the time point for the partition to automatically
arm itself.
- Late to Disarm
-
Enable the device to push a notification to the phone
or tablet to remind the user to disarm the partition when the
partition is still armed after a specific time point.
Note:
You should have enabled Operation Event
Notification on the Web Client of the security control
panel, or the notification will not be pushed to the
phone or tablet. For details about the Web Client, see
the user manual of the security control panel.
- Late to Disarm Time
-
Set the time point mentioned in
Late to
Disarm.
- Weekend Exception
-
If enabled, Auto Arm, Auto
Disarm, and Late to Disarm
are disabled on the weekend.
- Entry Delay 1
- Entry Delay 2
-
Set a value for Entry Delay 1 and
Entry Delay2. Entry delay is a time
concept. If entry delay is configured for the delayed zone, when
you enter an armed delayed zone, the zone alarm will not be
triggered until the end of entry delay.
Note:
After set value for Entry Delay 1 and
Entry Delay 2, you should set the
entry delay of a specific zone to the value of
Entry Delay 1 or Entry
Delay 2. see Set Zone Parameters for details.
- Exit Delay
-
Set exit delay for the delayed zone. If exit delay is configured
for the delayed zone, after you arm the zone on the indoor unit,
you can exit the zone without triggering alarm until the end of
exit delay.